Ets-lindgren 3850-2 LISN User Manual

Model 3850/2 Line Impedance Stabilization Network (LISN) User Manual

10 | Maintenance This page intentionally left blank.

Specifications | 11 3.0 Specifications Electrical Specifications Frequency Range: 9 kHz – 100 MHz (VDE 0876 specified curve ± 20% Lines Plus Gr

12 | Specifications This page intentionally left blank.

Installation | 13 4.0 Installation Before connecting any components, follow the safety information in the ETS-Lindgren Product Information Bull

14 | Installation Power Model 3850/2 Back Panel • The Model 3850/2 Line Impedance Stabilization Network (LISN) is nominally designed for a 50-

Installation | 15 • The input power connection to the line side of the Model 3850/2 is made through the red and black pin receptacles labeled L1

16 | Installation Equipment Under Test Model 3850/2 Front Panel • The Equipment Under Test (EUT) is connected to the Model 3850/2 through the

Installation | 17 Spectrum Analyzer / Receiver • Use the BNC connectors on the front panel to connect the spectrum analyzer or EMI receiver. See

18 | Installation This page intentionally left blank.

Warranty | 19 Appendix A: Warranty See the Product Information Bulletin included with your shipment for the complete ETS-Lindgren warranty for yo

ii | ETS-Lindgren L.P. reserves the right to make changes to any product described herein in order to improve function, design, or for any other reas

| iii Table of Contents Notes, Cautions, and Warnings ... v1.0 Introduction ...

iv | This page intentionally left blank.

| v Notes, Cautions, and Warnings Note: Denotes helpful information intended to provide tips for better use of the product. Caution: Denotes a haza

vi | This page intentionally left blank.

Introduction | 7 1.0 Introduction The ETS-Lindgren Model 3850/2 Line Impedance Stabilization Network (LISN) is a two-channel low pass filter net

8 | Introduction This page intentionally left blank.

Maintenance | 9 2.0 Maintenance Before performing any maintenance, follow the safety information in the ETS-Lindgren Product Information Bullet